dfw

**Dan12GT** · 08-10-2013, 08:54 PM

I finished this week painting the recessed lettering and sanding off the over spray (I should have tapped off). I'll need a bit more red as I sanded a few areas a little too low. I'll spray some red then 1500 the entire surface for clearing.

**Dan12GT** · 08-24-2013, 01:57 PM

End result:

Finished repainting some red then redid the black lettering.

Doing a rough tape off to prep for black paint on the lettering:

Sprayed the black:

Tape Removed:

Sanded black over spray with 1000 grit:

Sanding complete:

Final product after sanding the entire thing with 1500 and spraying clear:

There were some ever so slight rough patches I smoothed out by clay baring and polish.

Back on the car:

Intake Plenum cover next. I've begun sanding on it already. It will have a mix of gloss red / black to it as well. I will also do the fuse cover in red as well. Then on to some interior pieces.