Need a good exhaust shop in Fort Worth

[downtime!]

I always use Kinneys, especially now that they are off of Rufe Snow, just down the road. Definitely not the cheapest shop around, but they are one of the best. They've done 3 or 4 cars for me now, top notch work each time.

[Courtesy Flush]

Originally Posted by downtime! I always use Kinneys, especially now that they are off of Rufe Snow, just down the road. Definitely not the cheapest shop around, but they are one of the best. They've done 3 or 4 cars for me now, top notch work each time.

Love the location
Used him for a catback install on my 11, never again.
He fucked me over pretty good, i wont go into details as its water under the bridge but welding on a modular exhaust system is the just of it.

[downtime!]

Originally Posted by Courtesy Flush Love the location Used him for a catback install on my 11, never again. He fucked me over pretty good, i wont go into details as its water under the bridge but welding on a modular exhaust system is the just of it.

I'm surprised at that. He's been my go to exhaust guy for years, since he was way across town at the old location. He'll be cleaning up the Gearheads nightmare under my '12 eventually.

[Courtesy Flush]

Originally Posted by downtime! I'm surprised at that. He's been my go to exhaust guy for years, since he was way across town at the old location. He'll be cleaning up the Gearheads nightmare under my '12 eventually.

Hes a good guy, just somewhere along the lines we were not on the same wavelength on what i wanted done. I was very clear in explaining i wanted something modular i could remove and replace if necessary. Verbatim i remember saying do not weld anything.

Speaking of gearheads, i went to them about putting an offroad pipe on shortly after the Kinney's ordeal. They advised me to go to Phils muffler in FW.

Just for shits heres what happened.


Note the location of the x pipe, he cut my SS over axles and hacked up the stock midpipe to get this system in. When i got my offroad pipe and was wanting to get it bolted up , i was like 6-8 inches short from where the over axles meet the end of the midpipe.

When i called and asked Kinney's about putting the o/r midpipe on, he declined service saying it was illegal work.