| Performance Post anything performance related to your Mustang |
| Sponsored Ads |
|
|
Welcome to DFW50s.com
|
Register to remove these ads.
04-06-2014, 04:43 PM
|
#1
|
|
Junior Member
Join Date: Nov 2013
Location: Sachse
Posts: 19
|
MGW Shifter Install
I'm thinking about purchasing the MGW shifter for my Boss. Has anyone installed this themselves? If so, how tough was it?
Who around Dallas can I pay to install it and how much?
Thanks in advance.
__________________
2013 Boss 302 (0695)
Mods:
AED tuned
Ford Racing T Springs
Ford Racing Adjustable pan hard bar
Jegs cat deletes
Single tip GT500 Mufflers
Modified Whiteline bushing insert
Airaid Parnelli Jones CF CAI
Passenger side JLT Oil Separator
|
|
|
|
04-06-2014, 05:23 PM
|
#2
|
|
Senior Member
Join Date: Jan 2014
Location: TX
Posts: 285
|
There is install video on MGW website thats pretty thorough and its like an hour long. as far as getting someone to do it in your area (sachse) there is
Truestreet in Mckinney
HPP in Lewisville
Honestly if it were me I would save myself some $$$ and just DIY. Its not that hard at all and there are videos you can watch that will take you step by step. Good Luck
__________________
2014 5.0 Oxford White w/ Track Pack, 3.73's,
SR Lwr Ctrl Arms, Flowmaster Proseries AB,
Whiteline MT-82 bushing, JLT CAI, Bama Tune
1993 Cobra Black
Bbk shorty's, x-pipe, Flowmasters, bbk TB, bbk Cai,
UD pullies
(240rwhp/280rwtq)
|
|
|
|
|
04-06-2014, 07:20 PM
|
#3
|
|
Senior Member
Join Date: Apr 2013
Location: Tejas
Posts: 356
|
You can do it. Did my Barton without drama. Only hard part was fighting the rubber boot back on.
__________________
2014 GT Track Pack (300A) Black/Black, Recaros, Eibach Pro-kit, Koni adj (yellows), MM camber plates, Whiteline PHB & bracket, Whiteline adj rear sway,Hawk HP+, J+M SS lines,FRPP brake ducts, GT500 AB, 275/35/18 BFG Rivals on 18x10x43 D-force LTWs, Tint and blackout.
|
|
|
|
|
04-06-2014, 09:14 PM
|
#4
|
|
Junior Member
Join Date: Nov 2013
Location: Sachse
Posts: 19
|
How's the Barton as far as better shifting etc.?
__________________
2013 Boss 302 (0695)
Mods:
AED tuned
Ford Racing T Springs
Ford Racing Adjustable pan hard bar
Jegs cat deletes
Single tip GT500 Mufflers
Modified Whiteline bushing insert
Airaid Parnelli Jones CF CAI
Passenger side JLT Oil Separator
|
|
|
|
|
04-07-2014, 11:47 AM
|
#5
|
|
Member
Join Date: Feb 2014
Location: Haslet, Texas
Posts: 39
|
Installed the MGW shifter in my garage with a pair of ramps. With a lift it would have been a lot easier, if not use four jackstands. Hardest part was getting that rubber boot on. The videos are step by step and idiot proof. Took almost two hours start to finish.
|
|
|
|
|
04-07-2014, 01:22 PM
|
#6
|
|
Senior Member
Join Date: Apr 2013
Location: Tejas
Posts: 356
|
Originally Posted by RangerDLA
How's the Barton as far as better shifting etc.?
|
Very good.
Barton is pretty much a bang-bang affair as the throw is SHORT and rock solid when you get to the end. The nice part about the design is that the gates are still the same width apart.
I did mine with the 2-post bracket, and later added the whiteline trans bushing. Some NVH with the Barton/bracket, and quite a bit more with the bushing.
Unfortunately its its still on top of an MT-82  Trans is not the most refined unit in the world, but gets the job done. Feels draggy/nibbly when going into second in cold weather until it warms up. Like others, if the temps are low, I typically skip shift 1-3 until it warms up. No dramas this time of year.
__________________
2014 GT Track Pack (300A) Black/Black, Recaros, Eibach Pro-kit, Koni adj (yellows), MM camber plates, Whiteline PHB & bracket, Whiteline adj rear sway,Hawk HP+, J+M SS lines,FRPP brake ducts, GT500 AB, 275/35/18 BFG Rivals on 18x10x43 D-force LTWs, Tint and blackout.
|
|
|
|
|
04-08-2014, 10:13 PM
|
#7
|
|
Junior Member
Join Date: Nov 2013
Location: Sachse
Posts: 19
|
Thank you guys!
__________________
2013 Boss 302 (0695)
Mods:
AED tuned
Ford Racing T Springs
Ford Racing Adjustable pan hard bar
Jegs cat deletes
Single tip GT500 Mufflers
Modified Whiteline bushing insert
Airaid Parnelli Jones CF CAI
Passenger side JLT Oil Separator
|
|
|
|
|
04-08-2014, 11:18 PM
|
#8
|
|
Senior Member
Join Date: Aug 2013
Location: Haslet
Posts: 227
|
Just did mine. I could see how doing it on your back would suck but take your time. It's not bad. Don't waste time or money on the Barton when you can get the mgw for just a tad more.
__________________
13 Race Red GT | Recaros | Brembo package | 3.73s | MT82
Hypermotive Tune | Pypes Longtubes and O/R X | Corsa Sports | H&R Race Springs | Eibach panhard bar | BMR LCAs | BMR relo brackets | Koni yellows | Eibach sway bars | Ground Control CC plates | MGW shifter | SVE Drifts |
|
|
|
|
|
04-11-2014, 06:07 PM
|
#9
|
|
Member
Join Date: Aug 2013
Location: Trophy Club
Age: 74
Posts: 75
|
Ranger, MGW is by far the best shifter available.
if you don't want to mess with the install, call Matt at 21st Century Muscle Cars.
Steve
__________________
2013 Boss 302 PW, Recaro, Torsen, AED tune, Airaid CAI, MGW, Hotchkis Springs/LCA, Whiteline Relo, CHE K Member w/Torque Limiters, Griggs Torque Arm Kit, T/A rear girdle, Kenny Brown Pan Hard Bar, Whiteline Tranny Bushing, JPC Linelock, JPC stainless clutch line, MT ET Street Radials (when needed), , 2013 GT500 Quad Axle Backs, Kooks LT 1 3/4, O/R X Pipe, Resonator Delete, JPC Line Lock,JPC Clutch Line.
|
|
|
|
|
04-11-2014, 06:42 PM
|
#10
|
|
Junior Member
Join Date: Nov 2013
Location: Sachse
Posts: 19
|
Thanks, Steve. I'll give him a shout.
__________________
2013 Boss 302 (0695)
Mods:
AED tuned
Ford Racing T Springs
Ford Racing Adjustable pan hard bar
Jegs cat deletes
Single tip GT500 Mufflers
Modified Whiteline bushing insert
Airaid Parnelli Jones CF CAI
Passenger side JLT Oil Separator
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
|
Linear Mode
