| Sponsored Ads |
|
|
Welcome to DFW50s.com
|
Register to remove these ads.
12-30-2013, 08:43 PM
|
#16
|
|
Senior Member
Join Date: Mar 2013
Age: 34
Posts: 1,047
|
It was a pita for me. Ripped some paint off of my trunk too :/ No spoiler ftw.
__________________
The Queen:
2013 Race Red Mustang GT 6MT: 20" AMR's, GT500 AB, JBA LT's and ORX, SCT SF3/X3, MGW Short Throw, Some Carbon Wrap, Spoiler Delete, Eibach Sportlines, Koni STR.T's, BMR LCA's, BMR Relo Brackets, BMR UCA, Freedom Racing PHB, Maximum Motorsports CC Plates, BMR Safety loop, DSS Aluminum DS
|
|
|
|
12-30-2013, 09:53 PM
|
#17
|
|
Banned
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 39
Posts: 2,405
|
Tell me about it. Thanks Alex.
|
|
|
|
|
12-30-2013, 09:56 PM
|
#18
|
|
El Presidente
Join Date: Jun 2012
Location: Always ahead of Steve
Age: 35
Posts: 3,367
|
Yup lol not bad if you have a heat gun
__________________
2013 Ford Mustang 5.0 6M Brembo 3.73s
HPP TUNED HP-enough  4-0 vs Steve
|
|
|
|
|
12-30-2013, 10:04 PM
|
#19
|
|
Senior Member
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 42
Posts: 1,896
|
Originally Posted by JDMLOL
It was a pita for me. Ripped some paint off of my trunk too :/ No spoiler ftw.
|
You did it wrong then.
Originally Posted by Midnight11
Yup lol not bad if you have a heat gun
|
I just used plenty of Goo Gone.
-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376
Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
|
|
|
|
|
12-30-2013, 10:41 PM
|
#20
|
|
Senior Member
Join Date: Jun 2012
Location: Keller
Age: 62
Posts: 1,006
|
A little Goo Gone, a little heat gun and a little 50 pound test braided fishing line (with 2 sticks on the ends, used like a saw) and they come off quite easy. Also helps to do it on a hot Texas summer day.
__________________
|
|
|
|
|
12-31-2013, 12:16 AM
|
#21
|
|
Banned
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 39
Posts: 2,405
|
I did it in the 29 degree wind blowin out of the north at 30mph weather. Like a boss.
Last edited by re-rx7; 12-31-2013 at 12:53 AM.
|
|
|
|
|
12-31-2013, 12:24 AM
|
#22
|
|
Senior Member
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 42
Posts: 1,896
|
Originally Posted by re-rx7
I did it in the 29 degree wind blowin out if the north weather at 30mph weather. Like a boss.
|
Did you use double-sided tape on the new spoiler?
-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376
Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
|
|
|
|
|
12-31-2013, 12:52 AM
|
#23
|
|
Banned
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 39
Posts: 2,405
|
Originally Posted by Dominic Toretto
Did you use double-sided tape on the new spoiler?
-Alex
|
Yes, 3m. Followed the same outline that it came off with.
|
|
|
|
|
12-31-2013, 08:50 AM
|
#24
|
|
Senior Member
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 42
Posts: 1,896
|
Originally Posted by re-rx7
Yes, 3m. Followed the same outline that it came off with.
|
Might want to go over it with a hair dryer at some point. I can't be sure but, I was told that the tape needs to be warm to properly adhere. I have not tried to prove this on my car by removing the screws and pulling on it.
-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376
Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
|
|
|
|
|
12-31-2013, 11:25 AM
|
#25
|
|
Banned
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 39
Posts: 2,405
|
Originally Posted by Dominic Toretto
Might want to go over it with a hair dryer at some point. I can't be sure but, I was told that the tape needs to be warm to properly adhere. I have not tried to prove this on my car by removing the screws and pulling on it.
-Alex
|
I believe pressure is a more important factor then temp. I usually put C clamps on them for an hr so before removing.
|
|
|
|
|
12-31-2013, 01:13 PM
|
#26
|
|
Senior Member
Join Date: Jun 2012
Location: Gun Barrel City, Tx
Age: 42
Posts: 456
|
Originally Posted by my95z28
Looks good man! Any close up pics of how the 305/35-20s fit? Looking at putting some Nittos on a 10" wheel, trying to decide whether to go 305 or 315 since they run so narrow.
|
I have 315 NT05 on a 20x10 and they fit well. i've had no issues with them.
__________________
2011 Mustang GT - Sterling Grey - stockish
|
|
|
|
|
12-31-2013, 08:08 PM
|
#27
|
|
Senior Member
Join Date: Aug 2012
Location: Wylie
Age: 37
Posts: 2,266
|
Pic please?^^
__________________
2013 Deep Impact Blue GT Premium
386rwhp/383rwtq
|
|
|
|
|
01-02-2014, 12:51 AM
|
#28
|
|
Banned
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 39
Posts: 2,405
|
Clean shot after wash.
|
|
|
|
|
02-26-2014, 04:47 PM
|
#29
|
|
Banned
Join Date: Apr 2013
Location: Gainesville,Tx
Age: 39
Posts: 2,405
|
Last edited by re-rx7; 02-26-2014 at 04:56 PM.
|
|
|
|
|
02-26-2014, 04:51 PM
|
#30
|
|
Senior Member
Join Date: Jun 2013
Location: Irving / Oklahoma City
Age: 42
Posts: 1,896
|
Looks good man. You plan on keeping the factory grill?
-Alex
__________________
2012 GT Premium Hardtop with XX Transmission
Mods page: http://dfw50s.com/showthread.php?t=3376
Ford Racing . Pypes . BMR . CDC . American Muscle . DDM Tuning . BFG . J&M . Amsoil . MMD. JLT
|
|
|
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
|
