Dallas Fort Worth 5.0 Mustang Club
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Dallas Fort Worth 5.0 Mustang Club (http://www.dfw50s.com/index.php)
-   Performance (http://www.dfw50s.com/forumdisplay.php?f=30)
-   -   Noob header question (http://www.dfw50s.com/showthread.php?t=2678)

merlinmol 09-11-2013 12:58 PM
Most shops charge a flat rate for header install. Almost always $400.

JDMLOL 09-11-2013 02:39 PM
Quote:
Originally Posted by merlinmol (Post 49637)
Most shops charge a flat rate for header install. Almost always $400.
That's what I was charged.

Slowstang1_jgw 09-11-2013 02:45 PM
Sweet
 
Quote:
Originally Posted by wbt (Post 49634)
My car runs 10's N/A with them. I replaced a set of Dynatech headers with a set of Pype's. That car ran 180MPH at the Texas Mile naturally aspirated.

I can't definitively say how much they are worth as far as gains go but they are on some of the quickest/fastest N/A 5.0's out there.



Yes. I was running a Lethal O/R X with them.
I will be making a purchase for them soon, $$ for LT and then you have clearance issues. Thanks for the info

jayman33 09-11-2013 03:14 PM
Quote:
Originally Posted by Slowstang1_jgw (Post 49654)
I will be making a purchase for them soon, $$ for LT and then you have clearance issues. Thanks for the info
Ive installed 20+ sets of kooks. Never ran into clearance issues.

wbt 09-11-2013 03:26 PM
Quote:
Originally Posted by jayman33 (Post 49655)
Ive installed 20+ sets of kooks. Never ran into clearance issues.
Kooks are a mid-length design and they have recently produced a shorty.

The Dynatech's definitely had clearance issues with regards to how low they hung down.

The Pypes tuck in very nicely and don't have the same clearance issues. On-par with the Kooks and stock header/mid-pipe combo's.


All times are GMT -4. The time now is 01:43 AM.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.