Noob header question

[wbt]

Originally Posted by re-rx7 Pypes? Really? I would have never guessed. Are they pretty good headers concerned to BBK/Kooks?

My car runs 10's N/A with them. I replaced a set of Dynatech headers with a set of Pype's. That car ran 180MPH at the Texas Mile naturally aspirated.

I can't definitively say how much they are worth as far as gains go but they are on some of the quickest/fastest N/A 5.0's out there.

Originally Posted by Slowstang1_jgw Will aftermarket offroad pipes (lethal performance) bolt up or did you have to by BBK h/x pipes?

Yes. I was running a Lethal O/R X with them.

[Slowstang1_jgw]

Originally Posted by wbt My car runs 10's N/A with them. I replaced a set of Dynatech headers with a set of Pype's. That car ran 180MPH at the Texas Mile naturally aspirated. I can't definitively say how much they are worth as far as gains go but they are on some of the quickest/fastest N/A 5.0's out there. Yes. I was running a Lethal O/R X with them.

I will be making a purchase for them soon, $$ for LT and then you have clearance issues. Thanks for the info

[jayman33]

Originally Posted by Slowstang1_jgw I will be making a purchase for them soon, $$ for LT and then you have clearance issues. Thanks for the info

Ive installed 20+ sets of kooks. Never ran into clearance issues.

[wbt]

Originally Posted by jayman33 Ive installed 20+ sets of kooks. Never ran into clearance issues.

Kooks are a mid-length design and they have recently produced a shorty.

The Dynatech's definitely had clearance issues with regards to how low they hung down.

The Pypes tuck in very nicely and don't have the same clearance issues. On-par with the Kooks and stock header/mid-pipe combo's.