View Single Post
Old 11-25-2013, 05:03 PM   #16
DarkHorse1350
Member
 
DarkHorse1350's Avatar
 
Join Date: Aug 2012
Age: 44
Posts: 35
Default

Originally Posted by Dominic Toretto View Post
OP did your J&M panhard bar allow you to perfectly center your axle? I have the same item and my driver side is about 1/2inch out and the passenger side is about 1/2inch in. I plan to swap to a BMR part but for now, no one can tell.

-Alex
Yes, I was able to get it as close to centered as possible. When I installed the bar I fully seated both rod ends (screwed them in all the way, then I adjusted out from there, this will ensure that both ends are adjusted evenly and not one more that the other. Keep in mind that when you first install the bar this way your car will be all kinds of crooked, but as you adjust the bar a little at a time slowly but surely it will center itself.

I had to adjust measure, adjust measure, adjust measure several times until I was happy with the centering. Also use locktite on the jam nuts otherwise they can work themselves loose and you start all over.
__________________
KP

You must be fast cause you were haulin azz when I passed you!!

2007 Mustang GT Black with Gold Racing Stripes"Goldie", 5 Speed, 3.55 Gears, SVE Lowering Springs, JLT CAI, Roush Axle Backs, Bama Tuned! **SOLD**

2013 Mustang GT, Deep Impact Blue, 6 speed, 3.73's, GT500 Axle Backs, JLT Oil Catch Can, Sound Tube Deleted, SR Lowering Springs, J&M Panhard Bar
DarkHorse1350 is offline   Reply With Quote