View Single Post
Old 02-02-2014, 12:46 AM   #9
Dan12GT
Senior Member
 
Dan12GT's Avatar
 
Join Date: Jul 2012
Location: Roanoke, Texas
Age: 39
Posts: 818
Default

Originally Posted by Dominic Toretto View Post
I have the J&M aluminum one. Very sturdy piece and lighter than the stock part of course. At first I couldn't figure out how to get it properly adjusted but, Frank and I on here got it. To adjust it the easiest way put the car on a lift and load the rear axle so it will be as if the car is planted on the ground. Make adjustments as necessary on both ends. Use some locktite.



-Alex

Hmm I've always heard the opposite about J&M and to stay away from it. I wanna say I've seen a YouTube video of some guy under his mustang pulling down on the J&M PHB and it was bowing seriously downward with simple pressure of him pulling on it.

Like the saying. You get what you pay for.

OP, Go BMR and never look back!
__________________

Airaid CAI | Borla S-Type Catback | Amsoil 10w30 and MTG Trans. Fluid
382hp 387ft/lb | 1/4: 12.9 @ 112mph
Dan12GT is offline   Reply With Quote