[DirtyD]

Looking at new wheels and tires this summer if I can save up enough for them. The wheels I'm looking into are Niche Sport M131 Targa wheel, made by MHT Wheels.

I want to run a staggered 19x9.5/10 setup, and I'm stuck on the offset I will nee to get to avoid rubbing, but also flush the tires/wheels with the fender lip. Below are the tech specs pulled from MHT's site on the Targa.

Wheel Size: 19" x 9.5"
Fits: Mustang / Lexus Sedan
Bolt Pattern: 5 x 4.5"
ET: 35
Bore: 72.6
Load: 1600

Wheel Size: 19" x 10"
Fits: Mustang / Lexus Sedan / 350Z / G35 Coupe
Bolt Pattern: 5 x 4.5"
ET: 25
Bore: 72.6
Load: 1600

Plans are to run a 275/35/19 or 285/35/19 up front, and a 285/40/19 or 295/35/19 in back. I am also lowered on BMR springs, with roughly 1.25" front and 1.5" rear drop over the stock Brembo height with Tokico D-spec struts (and shocks soon).

So with the above offsets and tire sizes, with I have any issues with clearing or rubbing?