Cobra jet setup
 

Thought I would share my most recent project with you guys. CJ manifold, Monoblade TB, frpp intake, and frpp 47lb injectors! Install was not hard at all, just repining that TPS was a pain in the ass. Had it dyno tuned at gearheads performance in Arlington and it put down 432rwhp/378rwtq. pretty decent numbers with stock headers. only put half a car on my brothers 2016 gt with full exhaust lol :shooter: Anyways, here's some pics!:favorites37:

Sweet!

I've been eyeballing the CJ for a while


Well done!

Yea me too. Are these the only mods you have? Off road mid pipe or anything? Are the upgraded injectors necessary for this intake manifold?

Injectors are not needed. They are if you want e85

O ok cool, hoping to do this maybe later in the year. Do you guys go out to Ennis and race? I plan on going out there to run tomorrow night if anyone wants to join.

Nah, got a new born baby at the moment. For sure want to test out my new mods though eventually

only other performance mods are an off road midpipe and borla catback with x pipe. TEK is correct, stock injectors work just fine with this set up. 47lb for e85 and maybe a boost a pump wouldn't hurt. BUT thanks for the comments guys!

BAP isn't needed for e85 either.

I am curious....why did you choose the CJ?

HelloBeast, I sent a email to Ennis about running my 15 gt convert out there on Friday nights. No response. Worried that hard tops only allowed. Would like to get a quarter et without worries.

that's sweet. nice work on that