Dallas Fort Worth 5.0 Mustang Club

Dallas Fort Worth 5.0 Mustang Club (http://www.dfw50s.com/index.php)
-   General Discussions (http://www.dfw50s.com/forumdisplay.php?f=10)
-   -   Headers/off road H pipe (http://www.dfw50s.com/showthread.php?t=5088)

14s197 06-23-2016 12:53 PM

Headers/off road H pipe
 
What are some quality brand for headers and off road H pipe that will not completely kill my wallet? These kids will be going on a 14 5.0. Thanks in advance!

ac13 06-25-2016 12:28 AM

I like stainless works a lot. jba is another good one, stainless steel also. better prices than kooks headers without mids lol(1k). id stay away from bbk and pypes, that's just my opinion though

wayne fontenot 06-26-2016 11:15 AM

Best bang for your buck when it comes to figment and quality is stainless works

Grace 06-29-2016 12:03 PM

New here of course but wanting to put LT headers and off-road h pipe as well. I currently have a Pypes cat back, can I use a different brand for headers and mid pipe other than Pypes? I have a 2013 GT

wayne fontenot 06-29-2016 01:15 PM

Yes you can. I'd honestly stay away from pypes headers. The figment is horrible.

14s197 06-30-2016 12:49 AM

Just out of curiosity, why do you say to stay away from Bbk headers? I'm new to these kind of mods so I do not know lol

wayne fontenot 06-30-2016 02:31 PM

In my past experience the firmament is horrible. They won't line up. I've had to redrill all the flange holes to get them to fit. In my opinion that's poor quality

NAVAG 07-16-2016 12:51 AM

Stainless Works has the best bang for your buck IMO. There are some less expensive systems but if this is a DIY job with jackstands then I would pay more for proper fitment. I'm getting where laying on my back on the garage floor puts me out of commission for about a week.

3RD HNK 10-15-2016 03:42 AM

I run stainless works and have installed upwards of 150 sets of long tubes on the coyotes. Kooks and American racing headers are elite but high dollar, stainless works also very high quality with a price ideal for us as consumers. Jba is not too bad and priced accordingly. Bbk you'll really save and I feel like there drill isn't set on level ground at the shop lol. I'll do one set zero problems and the next set give me hell on the flange holes. Good luck with your decision

14s197 11-08-2016 12:06 PM

I believe I will be going with the Stainless works setup! Now I have another question?... Should I go 1-7/8th's or 1-3/4? I have mild boltons?


All times are GMT -4. The time now is 07:28 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.