Dallas Fort Worth 5.0 Mustang Club

Dallas Fort Worth 5.0 Mustang Club (http://www.dfw50s.com/index.php)
-   Terminators (http://www.dfw50s.com/forumdisplay.php?f=44)
-   -   Your Setup (http://www.dfw50s.com/showthread.php?t=1119)

Bearded Banger 02-08-2013 01:21 PM

Your Setup
 
Lets get a What you are running Thread going:

2.8 KB with 3.1 pulley, stock lower

Still Returnless, E85, Division X rails, 80lb injectors, dual FPDMS, GT Pumps, BAP, Fore Hat, tuned by 04Sleeper

Basic Boltons: Division X Idlers, JLT Intake

Making 720hp/689tq

What you got?

Emwun Garand 02-08-2013 03:19 PM

Basics

3.3L Lysholm, 3.5" pulley, stock lower, custom blower cams, Fox Lake Stage III heads. 21psi

Kooks 1-7/8" long tubes, off road x, 3" MAC catback

Return style, E85, Lysholm rails, 105lb injectors, 3x Walbro GSS342 pumps, Fore hat, BAP

Division X idlers, Vortech 5" intake and wide mouth throttle body, gt500 maf, a whole bunch of non performance stuff

817/687

fha8388 02-08-2013 04:14 PM

2.2 kb. 2.76 upper stock lower
Jlt next gen intake
80s , kb bap, gt pumps, stock hat , returnless e85
650hp, 540 ft lbs. Hpp tuned.
Gona get 04 sleeper to tune it soon:burnout:

aCid 02-09-2013 03:10 PM

Have all the shit just haven't put it on yet.

2.4 Polished KB with 3.5 Pulley
Lethal Performance Budget Return Style Fuel system
60lbs Inj.
BBK LT's / No-Cat BBK X-pipe / Bassani exhaust
JLT Carbon Fiber Intake

Right now with my current set up I'm putting down 460/480

Eaglei532 02-10-2013 02:51 AM

2.3L Gen 2 Whipple 3.3'' pulley, 4 Lb Metco Lower

GT pumps, Fore Hat, Dual FPDM, BAP, Tuned to 93

Basic Boltons: Bassani Mids, Bassani X, Bassani CB, BF Idlers, Accufab SBTB, JLT RAI, MGW shifter, STOCK SPRINGS, STOCK REAR(with BF brace) 305 555R DR,

Making ???hp/???tq. Couldn't even tell you the car needs a dyno but it needs a clutch before that sooo. I would venture about 580/535, but again I dont know yet

Stangmaster281 02-11-2013 09:11 PM

Quote:

Originally Posted by Eaglei532 (Post 19011)
2.3L Gen 2 Whipple 3.3'' pulley, 4 Lb Metco Lower

GT pumps, Fore Hat, Dual FPDM, BAP, Tuned to 93

Basic Boltons: Bassani Mids, Bassani X, Bassani CB, BF Idlers, Accufab SBTB, JLT RAI, MGW shifter, STOCK SPRINGS, STOCK REAR(with BF brace) 305 555R DR,

Making ???hp/???tq. Couldn't even tell you the car needs a dyno but it needs a clutch before that sooo. I would venture about 580/535, but again I dont know yet

whoops nevermind, I wasn't sure if u got my pm. lol

Modfox 02-11-2013 10:27 PM

Stock long block 2.3 TVS 19psi, return style fuel system, ID1000's,E85, kooks 1 5/8 headers,677/606
Tuned by 04sleeper

Grandpa 02-11-2013 10:52 PM

I know Foofinator's set up is pretty much -

Teksid blocked 302 stroker
ported heads
longtubes
3.08 gears
3.4 Whipple
custom cooler in the trunk
E85 tune
low boost near 800rw

blownaltered 02-12-2013 06:58 PM

Quote:

Originally Posted by Steve (Post 19243)
I know Foofinator's set up is pretty much -

Teksid blocked 302 stroker
ported heads
longtubes
3.08 gears
3.4 Whipple
custom cooler in the trunk
E85 tune
low boost near 800rw

So does he have tubes going through the interior of the car or is it underneath?

Bearded Banger 06-07-2013 09:14 AM

Your Setup
 
Small update. Have Kooks Headers, Custom 3" X-pipe (purchased from Emwum Garand, had all ceramic coated black) and 3" Polished Bassani cat back system just about ready to go on.

*waiting for the heat to hit before install so I can watch Eric sweat his balls off

Bearded Banger 06-07-2013 09:15 AM

Your Setup
 
Next will be fuel system and more boooooosssssttttt!

03MachMe 06-07-2013 09:47 AM

Are those new tires any good at putting your power down?

Bearded Banger 06-07-2013 12:36 PM

Your Setup
 
Once I heat them up. Yes much better.

Austin@BA-Speed 06-07-2013 09:16 PM

2003 Sonic Blue 110k+ miles

Fluidyne Radiator and Gords HE w/ dual fans

Girggs Tubular K-Member and lower front control arms
MM Front and rear coilover kit with bumsteer kit
MM Steering Shaft
Full Length Subframes
IRS bushing and stage 5 axles
McCleod RXT Twin Disc
StopTec Slotted Rotors

Not worth mentioning power mods, its a true slowbra with an Eaton, but it sounds damn good

Plans for a whipple or TVS in a year or two

WOMACK03 08-26-2013 06:45 PM

Quote:

Originally Posted by Bearded Banger (Post 18810)
Lets get a What you are running Thread going:

2.8 KB with 3.1 pulley, stock lower

Still Returnless, E85, Division X rails, 80lb injectors, dual FPDMS, GT Pumps, BAP, Fore Hat, tuned by 04Sleeper

Basic Boltons: Division X Idlers, JLT Intake

Making 720hp/689tq

What you got?

Your fuel system soon......:Caffeine:


All times are GMT -4. The time now is 08:04 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.