Cobra jet setup

[ac13]

Thought I would share my most recent project with you guys. CJ manifold, Monoblade TB, frpp intake, and frpp 47lb injectors! Install was not hard at all, just repining that TPS was a pain in the ass. Had it dyno tuned at gearheads performance in Arlington and it put down 432rwhp/378rwtq. pretty decent numbers with stock headers. only put half a car on my brothers 2016 gt with full exhaust lol :shooter: Anyways, here's some pics!:favorites37:

[NAVAG]

Sweet!

I've been eyeballing the CJ for a while


Well done!

[BeastStang1302]

Yea me too. Are these the only mods you have? Off road mid pipe or anything? Are the upgraded injectors necessary for this intake manifold?

[TEK302]

Injectors are not needed. They are if you want e85

[BeastStang1302]

O ok cool, hoping to do this maybe later in the year. Do you guys go out to Ennis and race? I plan on going out there to run tomorrow night if anyone wants to join.

[TEK302]

Nah, got a new born baby at the moment. For sure want to test out my new mods though eventually

[ac13]

only other performance mods are an off road midpipe and borla catback with x pipe. TEK is correct, stock injectors work just fine with this set up. 47lb for e85 and maybe a boost a pump wouldn't hurt. BUT thanks for the comments guys!

[wbt]

only other performance mods are an off road midpipe and borla catback with x pipe. TEK is correct, stock injectors work just fine with this set up. 47lb for e85 and maybe a boost a pump wouldn't hurt. BUT thanks for the comments guys!

BAP isn't needed for e85 either.

I am curious....why did you choose the CJ?

[Kaibab]

HelloBeast, I sent a email to Ennis about running my 15 gt convert out there on Friday nights. No response. Worried that hard tops only allowed. Would like to get a quarter et without worries.

[Must33]

that's sweet. nice work on that