Mufflers keep going askew

[south.texas.dead.I]

Just put on a new Roush muffler setup and centered them and after the drive I noticed that they drifted off center and one was bumped against the diffuser. What do y'all suggest?

[Toby]

Tack weld the clamp to the pipe on both sides. I've had this issue before.

[south.texas.dead.I]

Don't have access to one...?

[Toby]

Not sure where you are located, but stop by Truestreet, we can help you out.

[Mrjeremyt]

Don't have access to one...?

Any muffler shop can do this. I'll ask some of my buddies if they have one more local for ya instead of driving to north dfw.

[46Tbird]

Or just break out your big boy arms and get the clamp tight.

[south.texas.dead.I]

Or just break out your big boy arms and get the clamp tight.

The clamp was tightened down as far as they would go, metal to metal

[thelandshark]

They will move some lossen reset and retighten we had to.do this with oxford14 magnaflows an we used a 3/8 air impact but after reseting it worked out

[pohnjarker]

i have the same thing happening to mine and i found that the over axle pipes were hitting the axle and causing them to move...i'll fix it one day.